来源：财萃网 | 更新：2016-06-13 16:39:58 | 关键词：ACCA考试
In ACCA papers fifteen minutes are given to read the question paper . These fifteen minutes are also vital towards solving your whole paper as you solve in standard time of three hours .In these fifteen minutes you have to understand the requirements of the questions and then start thinking from where i should start solving the questions keeping in mind the requirements of questions and the structure of answers . So in short the trick is simply understand the requirements of questions and start planning of structures of answers. in these fifteen minutes . If you have done with this all and have some extra minutes then start drafting your answer on question paper , don,t waste your time !
Understand Question Requirements
Read requirements of the question and the question carefully . Don,t miss any point or line , understand it completely and then start solving the question . Understanding the question is very important , this will result in no cutting and clear to the point answer which examiner wants.
Answer to the Point
Marking scheme and answering to the point are relevant to each other . As above we have discussed how you should answer accordingly marking scheme the same case is here . When answering to the point you should try to write according to requirement , marks available for that query and the word used as query in question like as discuss , define , analyze , identify , explain , list etc. So this is a matter of common sense which applies here .
Structure up your Answers
Examiner wants and appreciates well-structured answers . Your answer should in adherence of questions requirements . The wording and solution should be simple and brief covering whole aspects of questions. This puts a good impression on examiner , the impression that you simply have tried your best to prepare your answers . And in case of time runs out, a solution just mentioning the key points of a question examiner may reward you a few good marks never thinking that the question is left incomplete. So always follow the required structure to gin some good marks easily.
Facilitate the Examiner
Always facilitate your examiner by
following required structure , writing to the point , writing clearly and
cutting on your answer sheet.
Always follow the sequence of requirements and the questions . Mention questions or company name in question on each answer on start as title .Name the questions parts clearly as a , b , c, etc. Start your new question always on a new full page . Don,t mix up different questions . Do your workings on right place properly this will help the examiner in understanding that from where the figures used in questions have actually came and how the have been calculated. Mark the question numbers clearly always and take a look at to follow the sequence of sub-parts to avoid confusion.Always write in line and within the permitted area of answer sheet don,t write on corners or cross lines and leave for examiner to seek your answer .In short avoid confusing examiner , that,s all !!
Don't leave any question Unanswered
Unanswered question puts a bad impression on examiner . if there is a time management problem or you are shortage of time try to just t format the answer,s major points but remember just in case when you are unable to complete the solution . Examiner will understand your problem and will reward you some good marks . So if you are just leaving your question completely unanswered the you might loose your marks and examiner confidence and this may contribute towards your failure.
Always try to solve your paper up to fifteen minutes before the exam time . If luckily you have done this , then review your answers completely and make corrections where needed . But remember don,t overwrite again and again .